What did you do on or to your CB 1100 today

[HondaLou]

Lou, ^^that^^ doesn't look good or professional, I see an ugly bolt thread.
For $10 or less, you can buy long hex nuts, cut them to the right spacer length, and paint them black or leave them silver. That’s exactly what I did with my DLX.
Buy the right size like 3/8 ID or larger to accomodet M8 bolt.

For example:

https://www.homedepot.ca/product/paulin-...1000131271

https://www.amazon.ca/Carbon-Steel-Galva...d_source=1

Yea.  I have a spacer for that section.  However there is no clearance between the bolt and garnish handle.   I could just cut a piece of black hose and slice it down the middle.  But once the seat is on, that section is completely covered and hidden. 
Thanks for the links.  Lou.