Yesterday, 10:34 AM
OK, I took another look while the tank is lifted. I took off the black plastic cover on the left side and could follow the EOT sensor cable. It is not a sub-harness, it comes out of the main wiring harness.
On my bike it branches out of the harness behind the chassis downtube (the one to rear of the airbox) right below a crosstube. So from there it goes down behind the airbox turns underneath the airbox and on to the sensor. There are some clips that hold the cable and other cables/tubes there.
I took a look at your harness on the parts fiche and it does show the connector and all, but is not labeled. Hope this helps.
On my bike it branches out of the harness behind the chassis downtube (the one to rear of the airbox) right below a crosstube. So from there it goes down behind the airbox turns underneath the airbox and on to the sensor. There are some clips that hold the cable and other cables/tubes there.
I took a look at your harness on the parts fiche and it does show the connector and all, but is not labeled. Hope this helps.
Holder of the CB1100forum Secret Decoder Ring
2012 ST1300
2013 CB1100
I find your lack of RLETs disturbing
2012 ST1300
2013 CB1100
I find your lack of RLETs disturbing