Fender rust...how to eliminate (revisited)

[pdedse]

About 6 bolts/nuts or so.
Did twice, on my '13 and '14

Those I can see well enough, it's the disconnecting of the tail light wiring that I'm unsure of.

I removed the rear fender along with the rear light, after disconnecting the rear L and R turn signals and the rear light connectors... under the tool tray??

Yes!  I was able to get the rear fender off.  What I was thinking was the tail light wiring...wasn't. 

Some threads from the past that help: 

https://m.cb1100forum.com/forum/showthre...?tid=15760

http://cb1100forum.com/forum/showthread....#pid271648

Once I realized what I needed to disconnect, then it wasn't so hard.  For the '17 models, it's only the tail light wiring, the turn signals wires stay put.

The other day I started to clean some of the rust off the underside of the rear fender; I got a good deal of it, but not fun due to the angle and hard to reach factor.  Now it should go better: