03-04-2016, 02:20 AM
I think my Qwest noise has been mostly solved. Based on some of the comments I read, I checked the seal on the top edge of the helmet and found that I could slide a piece of paper between the face shield and the seal on the helmet. NOT GOOD! I then found that the plate which holds the face shield on the helmet is adjustable so loosening both screws allowed movement of the base plate back and down. Did this for the other side, reinstalled the face shield and the air gap was gone. A short test ride and I estimate a reduction of wind noise by 2/3. I can live with that. Thanks everyone.