Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Redneck 3D Printing
#4
That is a nice low profile support Gone, looks good and a surprising small amount of up tilt for the gopro.
I suppose you check "recording" in your mirror do you?
My mount allows to disconnect from the helmet in an "event" ( see michael shumacher ) and horizon adjustment which i check whilst sitting on a flat surface.

It is a learning process to optimize results to the standard you're happy with, i found that a heavy overcast sky overwhelms the video so i tilt down on those days or not use the cam altogether, it depends what the footage is used for.

Sun in the back video always looks nice, good progressThumbs Up
Reply


Messages In This Thread
Redneck 3D Printing - by Gone in 60 - 09-18-2020, 02:01 AM
RE: Redneck 3D Printing - by peterbaron - 09-18-2020, 02:18 AM
RE: Redneck 3D Printing - by the Ferret - 09-18-2020, 03:04 AM
RE: Redneck 3D Printing - by max - 09-18-2020, 05:14 AM
RE: Redneck 3D Printing - by pekingduck_imp - 09-18-2020, 10:43 AM
RE: Redneck 3D Printing - by peterbaron - 09-18-2020, 10:55 AM
RE: Redneck 3D Printing - by pekingduck_imp - 09-18-2020, 12:17 PM
RE: Redneck 3D Printing - by Gone in 60 - 09-18-2020, 04:33 PM
RE: Redneck 3D Printing - by pekingduck_imp - 09-18-2020, 09:13 PM
RE: Redneck 3D Printing - by Gone in 60 - 09-18-2020, 11:39 PM
RE: Redneck 3D Printing - by pekingduck_imp - 09-19-2020, 02:03 AM
RE: Redneck 3D Printing - by Gone in 60 - 10-09-2020, 03:08 AM
RE: Redneck 3D Printing - by GoldOxide_imp - 10-09-2020, 11:53 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  More Redneck 3D Printing Gone in 60 13 731 01-19-2024, 10:55 AM
Last Post: Gone in 60

Forum Jump:


Users browsing this thread: 1 Guest(s)