|
More Redneck 3D Printing
|
01-15-2024, 05:57 AM
A little of both, probably! I had previously tried using really thick 3M foam adhesive strips, but they didn’t conform well enough to stay fully attached. I never considered looking for any putty-like products.
Since my Sena adhesive mount encounters a similar problem, I’ll give the JB waterweld a try for it! Thanks for the tip. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
More Redneck 3D Printing - by Gone in 60 - 01-15-2024, 04:43 AM
More Redneck 3D Printing - by 3rd_Gear_Steve_imp - 01-15-2024, 05:45 AM
RE: More Redneck 3D Printing - by Gone in 60 - 01-15-2024, 05:49 AM
RE: More Redneck 3D Printing - by GoldOxide_imp - 01-15-2024, 05:55 AM
More Redneck 3D Printing - by 3rd_Gear_Steve_imp - 01-15-2024, 05:57 AM
RE: More Redneck 3D Printing - by Cormanus - 01-15-2024, 06:10 AM
RE: More Redneck 3D Printing - by Gone in 60 - 01-19-2024, 08:29 AM
RE: More Redneck 3D Printing - by Cormanus - 01-19-2024, 08:38 AM
RE: More Redneck 3D Printing - by Gone in 60 - 01-19-2024, 08:41 AM
RE: More Redneck 3D Printing - by GoldOxide_imp - 01-19-2024, 08:46 AM
RE: More Redneck 3D Printing - by Gone in 60 - 01-19-2024, 08:51 AM
RE: More Redneck 3D Printing - by Cormanus - 01-19-2024, 08:52 AM
RE: More Redneck 3D Printing - by pdedse - 01-19-2024, 10:29 AM
RE: More Redneck 3D Printing - by Gone in 60 - 01-19-2024, 10:55 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Redneck 3D Printing | Gone in 60 | 12 | 776 |
10-09-2020, 11:53 AM Last Post: GoldOxide_imp |
|
