06-11-2014, 12:40 PM
Well just got my tire repair kit, Cruz tools metric kit today, and one of there 27mm (as well as 22mm and 14mm) combo wrenches. I missed that they had a 32mm one as well and went with one that had a tire spoon on the other end instead from another company. The 27mm fits on top of the box just barley. The good news was that the 32mm was a bit longer and so you could actually get enough leverage to turn the axle nut, the bad news is it is a bit longer and wont easily fit in the tool box.
I may still get the 32mm combo, to put under the seat, but with what I have now I can at least tension the chain. It was actually a bit slacker then I would want from the dealer. I was able to originally move it a little over 1 1/2" now I got it down to under 1 1/4". It also lines up with the mark on the side that says where a new chain should be. I'm going to keep an eye on this, and see how often I have to adjust this, hopefully I wont very often. Everything else that I looked at seemed to be in spec. I'll check it all again at 600 miles, but keep a closer eye on the chain, probably check it each day I ride.
I may still get the 32mm combo, to put under the seat, but with what I have now I can at least tension the chain. It was actually a bit slacker then I would want from the dealer. I was able to originally move it a little over 1 1/2" now I got it down to under 1 1/4". It also lines up with the mark on the side that says where a new chain should be. I'm going to keep an eye on this, and see how often I have to adjust this, hopefully I wont very often. Everything else that I looked at seemed to be in spec. I'll check it all again at 600 miles, but keep a closer eye on the chain, probably check it each day I ride.