Take that wind!

[flynrider]

Looks good! I initially thought I wanted the Street Shield, but ended up going with the slightly smaller Deflector instead. I was concerned that the Deflector only used two handlebar mounting points, but it turned out to be solid as a rock.

The hose clamp is standard for any of National Cycle's 4 point mounted shields. One warning, make sure that they are as high up on the forks as possible. I had a National Cycle Plexi 3 on my CB750 and installed the clamps above the "dust line" on the tubes. That worked fine until I put about 80 lbs. of gear on the back for a camping road trip. Turns out the front end dives a lot farther with a load on the back. Within 700 miles I'd toasted both fork seals. Expensive and frustrating lesson.