How to set my new tank pad.

[FUZZY_imp]

Get painters tape. Position on tank before removing adhesive backing. The painters tape should run center of pad across from side to side. Now you have 2 options & either will work. Wet: use spray bottle w/soapy water(not too much soap). Start removing adhesive backing from one end working back toward tape. Use scissors to cut backing @ tape area & be careful not to let pad touch itself or tank. Spray pad & tank with solution & slowly work pad down on tank from tape out to end using a plastic squeegee to remove air bubble & soapy water as you go. Repeat on other end of pad except just remove backing, nothing to cut. Check you have all bubbles water out. Let it set for 30 min. to remove outside film over pad if it has one. Works same way dry except you use nothing but squeegee. No soapy water. It's very easy & it will be where u want it.