Bits and Pieces

[CB4ME_imp]

UPDATE:

Installed everything but the turn signals. Levers were a breeze, but I had to modify the SP Takegawa pegs by filing off a tiny roll-pin attached to the pegs. That pin works if the pegs are set higher, forward, or backward but not lower. I also had to add a washer as a spacer to make the lower position work.

Good news and not so good news on the Japanese rear turn signals. The good news is that it's literally a snap to connect them. There's a bundle of snap type connectors in the battery compartment. Disconnect the US signal, snap in the Japanese signal. You're done.

The not so good news is that the grab bar needs a minor modification to accomodate the signals. You can see this in the photo. It's probably a 10 minute job to open up that notch area. Otherwise mounting the signal to the grab bar is as simple as using the supplied nut and washer to tighten things down.