Vololights: Enhanced Motorcycle Visibility by Vectolabs, LLC

[vfrpaul98_imp]

your rear tail lite bulb contains two filaments. the tail lite(running lite) filament powers up(illuminates) when you turn your keyswitch to the on position. you bikes red tail lite lens is illuminated and the bottom side of the lens(clear) illuminates the license plate. the black/brown wire color in the tail lite harness is the wire that carries the 12 volt current to the tail lite filament. the current stops when you turn your keyswitch to the off position. the green wire in the tail lite harness is system ground wire. I would assume these would be the needed wires to complete the installation of this product.
the green/yellow wire in the tail lite harness carries 12 volt current from the front or rear stop lite switches to illuminate the brighter stop lite filament of the same stop/tail bulb. both wire colors do not carry 12 volt current with the keyswitch in the off position.
questions? just ask your fellow forum members here.
Paul.