Clear bra

[geosar_imp]

I followed Scoobynut's how-to-do thread and had good results. It requires patience and heat to ride the learning curve.

I am very happy with the panel I installed. I placed a sheet where the seat abuts the tank and it is very difficult to see. There is a blemish which is my fault-I trimmed the top margin off hastily and have a ragged edge peering out above the seat. But only if the light hits it perfectly does it show.

It is doable. Just pay attention to the instructions. What took a while was learning to STRETCH the material to eliminate the bubbles. Also spray that soapy stuff liberally and learn the art of the squeegee. Do it in the sun. My bike is red and the clear bra works very well.

If you are a poser wrencher like me, it might be fun to try it yourself. In my old age I am trying to take the mystery out of things I have formerly left to "experts"- to be able take care of the peripheral aspects of the bike.

For me it has been satisfying to attempt some of the mods for our new bike. Kind of makes you feel accomplished and independent. Besides, if you do not like the clear bra just remove and install another. No harm no foul.

Go Arizona!

George