Fork Boots

[White Dog_imp]

The gaiters I purchased from RevZilla (part #150125, which is also HD-03212) fit snug at the top (41mm) and are slightly loose at the bottom. The specs say the bottom diameter is 2 9/16" whereas I measure 2 1/2" diameter of the fork seal cover. So, the gaiter bottoms are a loose fit. I did not use the zip ties to attach the bottom sections--yet. I want to see what they do when I am riding. Even if water from the road were to get into the gaiters by them being loose, that same water will drain out. I might even flush the insides of the gaiters after a wet ride then blow dry them with my air compressor. These gaiters have no drain holes so if I were to shim the bottoms to fit tight, then zip tie them, I'd have to poke drain holes in the gaiters. The bottom part of the gaiters overlap the fork seal by roughly 1 1/2".