pull back

[Redbird_imp]

Here are some pics of how I mounted mine while using the SW-Motech pullback risers. To get the fairing supports to contact the handlebar clamps and lay flat, in addition to the Parabellum supplied spacer, I added a nut as an additional spacer

[url=https://redbirdpics.smugmug.com/Fairing-mount/n-bVzPwp/i-rnbLkr7/A]

I used a washer stack that's about the thickness of the nut at the other end

[url=https://redbirdpics.smugmug.com/Fairing-mount/n-bVzPwp/i-2hX4hbS/A]

Another view

[url=https://redbirdpics.smugmug.com/Fairing-mount/n-bVzPwp/i-LT8mRLq/A]

Here are the risers

[url=https://redbirdpics.smugmug.com/Fairing-mount/n-bVzPwp/i-LNnxq4T/A]

I removed the tie that held the wires and hoses to the handlebar and just tied them together. I also bent the wire retainer on the right side of the instrument cluster away enough so that the brake line could slide inside it. That is a fairly thick and stiff retainer -- I used a slide hammer with a gear puller attachment to pull it away from the cluster. Hook one of the gear puller ends over the retainer wire and have at it until there is enough clearance.

[url=https://redbirdpics.smugmug.com/Fairing-mount/n-bVzPwp/i-Gg4pL67/A]

I would think the genmar risers would install similarly. The ROX risers for 7/8" bars may also work for the fairing mount since you retain the original handlebar clamp when using them. I'm not sure that you would have enough brake/clutch line length when using the ROX risers though.

Ken