My new arse

[Jaychaynes_imp]

The PO had the tail light and license plate bracket relocated down on the side of the bike, which I though was dangerous, not to mention unfitting for a bike that wasn't a Harley. There's also some rust build up on the underside of the fender, and I want to get that off before coating the bottom of the fender with something... Maybe plastidip? Any tips on rust removal?
Anyways, I bent some emt conduit and ran the wiring through that, adding some electrical disconnects since the PO had cut the wiring. I also cut some sheet metal to the bend of the bar to act as a fender for now. All stock parts are reinstall-able at any time, but I'm kinda digging this no fender look. Next move is low bars or clip-ons up front and a seat.




Sent from my iPhone using Tapatalk



Sent from my iPhone using Tapatalk