New Emgo shorty reverse cone exhaust on my 2014 CB1100

[dsinned_imp]

Cool!!! Congrats on finally getting this to work! Sounds GREAT!!!

Were you able to incorporate a "landing" for the center stand stop? I see the stand is still on your bike, but can't tell if there is a stopper bracket anymore.

How much for the Nickson adapter? I think Walker makes the same thing for $3 available at my local auto parts store. In fact, here's something similar, that is a straight 2-5/8" long pipe section, with 1-3/4" ODs at each end. Wouldn't this eliminate the reducer at the Emgo inlet?

[url=http://www.oreillyauto.com/site/c/detail/WAL0/41925/N1560.oap?ck=Search_N1560_WAL_1502074_-1&mn=Walker&mc=WAL&pt=N1560&ppt=C0233]http://www.oreillyauto.com/site/c/detail...&ppt=C0233

Ideally, a chromed short extender pipe, approximately the same end to end length, with a slight "S" bend, would make for an aesthetically better installation when viewed from the rear of the bike. OTOH, the splayed angle of the muffler from the center line of the bike, is not half bad looking "as-is".

How does it sound when you're really on the throttle while riding?