SW motech risers...black!

[pdedse]

What did you do for throttle cables and brake line? I'm trying to install the same risers. I don't like the way the cables stretched and the brake line is tight. I don't see a way to reroute them.

Sent from me......

I did not adjust the cables or brake line. I attached the base of the risers, lifted the handle bars up and the cables were tight as I tried to lift the bar over the highest point of the base of the riser. But once I gently coaxed the bar over the highest point of the riser base, the bar then settles down into the groove. I did notice that if I tried to rotate the handlebar down at that point that soon the cables felt tight again. Moved the bars slightly up, and there was slack again. I tightened everything down, started, and turned hard right and left and didn't notice anything tight. Test road and the bar is a little crooked, maybe off by 1/8", so I need to straighten that, but the cables seem ok to me. Another forum member also said he installed these and did not have to adjust the cables nor brake line. My bike is a '14 standard.