Staintune Exhaust

[Gumby 1100_imp]

If I remember aright, this is the only reported install where there have been problems.

No, I reported a clearance issue too on my 2014 Canadian. Even after bending the Staintune hanger bracket a bit, I still only have a little over 1/8" (4mm) clearance to the shock bolt. There would have been no way to hang it from the "outside" as the link fitting to the header would not allow that kind of misalignment. I know that I had bent the hanger bracket for much more than 1/8" clearance, but as soon as I tightened the link clamp to the header I lost that extra clearance; so it is not just a hanger bracket alignment issue.

I could always remove the muffler and bend the bracket a little more, but nothing is hitting, so I will leave well-enough alone...for now.

The Staintune was designed to fit the 2013 and earlier bikes, so there must have been some subtle design change to the 2014 bikes. Staintune was supposed to be tweaking the fixture after I had the fitment issue.