Staintune Exhaust

[Ulvetanna_imp]

Maybe try pages 1 and 2 of this thread Ulvetanna. Not sure if that's what you're wanting.

24 dang pages I can't read it all...
Yeah that answers my question, I was thinking along the lines of what Capo was wondering, maybe the thing needed to be mounted on the outside of the footpeg bracket. But that pipe on Page 2 is mounted to the inside. But it is DARN close clearance. They really should have designed the mount to give it another 10mm of clearance. If that's the correct way to mount it, that is. I would like to see any other guys' mounting setup, are all the bikes mounted to the inside, or maybe that just seems right and some guys do it that way.

I remember mounting up a Dale Walker Holeshot slip-on to my 2005 FZ1 and it could be put on either way, and I'd get bored and switch it for the stock can again (the bike ran MUCH better that way too) and then get bored and reinstall the Holeshot. I'd always forget which way it went and a couple of times I mounted it wrongly.