The transformation of my CB

[kennyw]

Came home to a good surprise.


Took the rear fender and factory turn signals off again. With a little paint, the new brackets were remounted with the new turn signals.



Next, routing wires under the taillight and into the fender. One new half inch hole drilled in the fender with a grommet to bring the wires under the seat.










Extra 3/8 indinch holes were drilled in the plastic piece for routing wires.

After that, the new assembly is reinstalled on the bike.






Next will be wiring. I just ran out of time and energy to finish it up tonight.