CBR1000RR Front End?

[Cafe Project_imp]

No, absolutely not, but you can make it fit with some parts. Cognito Moto has the custom parts. Hit eBay for the rest. The CB1100 steering stem is welded into the triple trees and the GSXR fork legs are way wider. What you need are GSXR upper and lower trees and a hybrid stem. The stem is press fit. Believe me, it is a press fit. I tried hammering and I tried freezing one side and heating the other. Its a press fit. Plus the GSXR upper tree has the GSXR ignition cut out which does not fit the CB. The lower GSXR tree can be made to fit but you will want to grind off the steering damper bracket and the steering stops and drill and tap for new stops (available from Cognito Moto). I would recommend custom, billet upper and lower tree clamps from Cognito Moto, steering stops, hybrid stem (have them press fit it too), AllBalls taper roller bearings (hybrid all from CM). You will also need GSXR wheel, brakes, forks and spanner nuts. You will also need a CB1100 spanner nut socket and a GSXR750 spanner nut socket (I made my own - it's a long story). The CB1100 ignition will not fit, I have a MotoGadget RFID system. The horn, indicators and headlight wont fit either. I have suggestions if you need them. Lastly (LOL) you will also need the radial Brembo brake lever assembly from a GSXR and some levers that match (I bought a matched set of CB levers and a set of GSXR levers and kept the CB clutch and the GSXR brake). Lastly (really this time) clips ons. I have a set of 7/8 clip-ons from Woodford in anodized black with a 1 inch rise (from Cognito Moto again). I also have Motogadget blaze turn signals and instruments as my CB1100 instruments and turn signals were destroyed. There is also some mechanical engineering along the way. I have pictures and can help with any of this. So, do they bolt on? Yes they do!