Thinking of a new gadget...

[GoldOxide_imp]

Was a bit surprised to learn that most of you (who sent me a PM showing interest in the final device) would prefer to have it pre-attached to the angled mount. This brings me to the following idea: will check if I could cram the electronics of the center module into the angled mount itself. That would make it a "single module" device. Will be back with the result soon. This will not require re-designing electronics (it is already as small as it could be), just a new angled mount to be printed if dimensions seem to be ok.

If you consider this optimization, then please consider not permanently affixing the Display Module (DM) to the Central Module (CM). This will allow the option to affixing the DM at "normal" or upsidedown on the angled mount so it can be placed elsewhere, instead of on a hydraulic reservoir.

That said, maybe consider a second choice (or an additional BOM item) "non-angled" mount (basically a rectangular matchbox) to affix the DM. The advantage of this is the electrical connection between the DM and CM won't have to be concerned about orientation to each other.

In short, across various riders and machines, the flexibility for mount should be maintained for universal application and wider deployment acceptance.