Thinking of a new gadget...

[Csory_imp]

(...part 2/2)
The black "shield" glued in place with quick-setting epoxy. This part is meant to center and hold the display in place (and prevent potting silicone from getting to the front glass) and is not visible from the outside.



...and fitted into the housing. Went with the original idea - 3d printed ABS, epoxy lacquered and matte black painted.



This is what the new color looks. It is much better in real life Once installed on the bike will post a video too, that will give it justice



..and thanks for reading all this and following my project
GoldOxide: Thank you. /personal mode ON/Actually, I'm a mechanical engineer by education, computer programmer by profession, serial entrepreneur by career, and love (among many other things) electronics as a hobby... A mile wide, an inch deep - and truly enjoying every minute of being like this /personal mode OFF/