Thinking of a new gadget...

[Csory_imp]

Parts arrived - it was time to see if the housing fits! There were a few gotchas (there are always a few gotchas...) Found that epoxy resin can be peeled off with a knife relatively easily - will try sanding, acetone bath and then spray acrylic for the housing. Also, trimpots are too fiddly to calibrate voltage measurement - will go with software calibration instead. This will be burned in once the panel is complete to match the exact characteristics of that given set of parts. Power consumption is between 10 and 30mAmps (depending on screen brightness), not that bad at all. The pictures below show how cramped this thing is. Will have to re-arrange parts to have access to the MCU for post-soldering reprogramming though... Also added a movie, just to show off