Sissy bar and rack.

[treytexag_imp]

Racer, thanks for the note.

Don't take this the wrong way. But box it up and take it to your local garage and have him do it. From your previous post you stated you are not mechanically inclined. The job is fairly simple and simple to figure it out. You use the front hole and drill a new rear hole. Then I used a grinder with a cut off wheel to shape and fit the side mounts for seat clearence. Then just smooth the cuts and edges with a soft disc on the grinder. Not hard at all. But I am welder fabricator. That's what I do. I think computer stuff is hard. So I get people to do that stuff for me. It's not my cup of tea. No shame in getting the job done right by the right person. So please don't take this post the wrong way.