3D printing - help needed

[The Gecko_imp]

it has a molded in contact pad?

thats a different ball of wax.

as a side note, yes, i went to firefox installed it as a browser, still the same. both machines i use are windows 11, but even my galaxy phone shows it broken. It needs to be fixed on the hosting side, i've seen this before (and know a bit about it as i run my own site). I could probably work around it but a lot of the stuff on here isnt important, to me, but i still check it on occasion, (obviously).

as for the adapter : yes, that is why I need to use a separate 3D-printed holder (as shown in the link) AND the original adapter (shown in the picture). In other words
- the original adapter holds the satnav, and provides power to it
- the additional holder holds the adapter (by holding the ball).

as for the broken site : now I see, and here is the rub, it happens to me too (with FF) once in a while, all I have to do is reload the page and the problem is gone for that session. I am sure you tried that too ....