12-28-2020, 10:55 PM
The CB1100RS I'm getting will be my very first brand spankers new bike!!
Apart from sitting staring at it and grinning like a loon, is there anything I need to do other than making sure it left the Dealer's properly prepared/PDI'd, like chain tension, fluid levels and the like or should I be looking at the explicit checking of 'certain things'?
Do I need to do any special protection of bolt heads, shiny metal bits etc?
I've had sufficient new cars to get extremely blasé about them, basically get in/drive off, but for bikes this will be a whole new experience.
Advice and guidance from the assembled Hive will be most welcome.
Apart from sitting staring at it and grinning like a loon, is there anything I need to do other than making sure it left the Dealer's properly prepared/PDI'd, like chain tension, fluid levels and the like or should I be looking at the explicit checking of 'certain things'?
Do I need to do any special protection of bolt heads, shiny metal bits etc?
I've had sufficient new cars to get extremely blasé about them, basically get in/drive off, but for bikes this will be a whole new experience.
Advice and guidance from the assembled Hive will be most welcome.