CB350 Resto-Mod Cafe'

[Razor]

Sorry for the long delay (took the summer off from projects).

Not much to update, but thought I'd pass along some more details.

Before ordering the custom throttle cable from Motion Pro; had to clean & rebuild the carburetors. Soda blasted followed by a good cleaning in the ultrasonic cleaner. Also polished the bowls.




Bought some pod filters that needed to be shortened.
The section in the right is what I cut off. The springs were cut down also, then reinserted after the glue dried.






For those with a sharp eye... you might have noticed the drive chain tensioner in the last photo.

Here's some details.
Had a used tensioner. Can't remember what bike it was from. Needed to be cleaned & refurbished. Also had to fab a new bracket to hold it onto the swingarm.



Made a new rubbing block out of Delrin (wider than original)






Without


With, chain rides on rubber swingarm guide.