06-10-2019, 06:30 AM
(06-10-2019, 05:05 AM)Rboe_imp Wrote: I seem to recall (but don't take too much stock in my memory) that the dowels will come out. No mar pliers should pull them out. .
The bearing on the other hand; in theory should come out but in your case a new bearing is probably the best coarse to take.
There are higher output after market stators to be had (I put one in my bike after the original stator started to fail) so you can run things like heated gear. Not too expensive either.
I had to order the bearing anyway, the dowels were only a couple dollars more, and it won't go together any quicker than the order with the bearing so I went ahead and ordered them to make install less fuss.
Not sure I care enough about a stator today but it would be easier to replace at the moment...