07-05-2015, 05:53 AM
Just completed 1st service following this guide and it worked out great.
Oil filter was so tight I had to get my big pair of channel locks on it, the paint was scraped from the block where the metal from the filter scraped into it during assembly.
Oil plug was fairly loose but tight enough as it never leaked.
I held back about an ounce of oil from the gallon I purchased as recommended and it took it right to the upper mark perfectly.
Chain had 2" of slack, adjusted that into spec.
Everything else looked good.
Thanks again for the great write up!
Oil filter was so tight I had to get my big pair of channel locks on it, the paint was scraped from the block where the metal from the filter scraped into it during assembly.
Oil plug was fairly loose but tight enough as it never leaked.
I held back about an ounce of oil from the gallon I purchased as recommended and it took it right to the upper mark perfectly.
Chain had 2" of slack, adjusted that into spec.
Everything else looked good.
Thanks again for the great write up!