04-26-2014, 10:09 AM
(04-25-2014, 10:13 AM)lccb1100a_imp Wrote:(04-25-2014, 07:20 AM)Deanohh_imp Wrote: Both the meter and ecu get a signal from one wire coming out of the abs unit. I think its pink and blue. If no signal or bad signal you'll go into limp mode. Check for continuity this wire.
The speedo is analog. Whether it's being driven by a digital signal is another question. He did say after I mentioned the pink blue wire that he had not traced the wire all the way back because it's buried and he'd have to take the whole center of the bike apart. He said that the signal was getting to the abs box, and the meter was fine, but from what you are saying even if this signal is fine the signal to the ECU may not be. But he said it's not throwing any error codes saying the abs is bad. Wouldn't it be saying this if the cable was bad?
(04-25-2014, 09:30 AM)Ridem32_imp Wrote: Check the tip over sensor. When the bike is laid over the tip sensor kicks in. I saw in my 2014 shop manual it has 2 I think. But there under the seat one could be bad or needs to be reset. Most of the time cutting key on and back off resets it.
Michael
I will have him do that.
Whoever gets this right wins my "Hero of the day" award. I'm not quite sure what that is yet, but I'll think of something.
The speedo is analog. Whether it's being driven by a digital signal is another question. He did say after I mentioned the pink blue wire that he had not traced the wire all the way back because it's buried and he'd have to take the whole center of the bike apart. He said that the signal was getting to the abs box, and the meter was fine, but from what you are saying even if this signal is fine the signal to the ECU may not be. But he said it's not throwing any error codes saying the abs is bad. Wouldn't it be saying this if the cable was bad?
(04-25-2014, 09:30 AM)Ridem32_imp Wrote: Check the tip over sensor. When the bike is laid over the tip sensor kicks in. I saw in my 2014 shop manual it has 2 I think. But there under the seat one could be bad or needs to be reset. Most of the time cutting key on and back off resets it.
Michael
I will have him do that.
Whoever gets this right wins my "Hero of the day" award. I'm not quite sure what that is yet, but I'll think of something. I am with Ridem32 on that one.