Low end sputter, hesitation

[Inhouse Bob]

Good job, Gumby. You saved me having to go out in the rain and take it all apart and photograph it. Thanks for that!
One note. Tracing the wire from the O2 sensor (which is found on the top of the muffler, near where it joins the header) back to the connector was tricky until I noticed that the two wires that converge within the silicone shroud beneath the right side cover and might possibly be confused with one another have different textures on their insulation. The correct one on mine had a sort of snakeskinish look, while the other was smooth. Yours might be different.

Edit... That is one ugly sentence you wrote there, Bob