01-02-2019, 04:49 AM
(12-30-2018, 10:41 AM)pekingduck_imp Wrote:(12-30-2018, 09:59 AM)FLYTYM_imp Wrote: Anybody pulled the engine covers off and if so how much of a hassle was it? I understand there is no gasket,only sealer,I tried pulling the left cover off but no dice without prying on it somewhere.
I pulled the covers off recently with no problems. The left one has a dowel pin at the lower front. Be sure you take the small 3-bolt cover off first, take the shaft out and slide the gear out. This will give a nice spot to tug from.
On the right side, pull the oil filler cap and the center plug out to tug from. The smaller cover has 2 dowel pins, the clutch cover has none. Tap with a plastic or rubber hammer if needed.
I pulled the covers off recently with no problems. The left one has a dowel pin at the lower front. Be sure you take the small 3-bolt cover off first, take the shaft out and slide the gear out. This will give a nice spot to tug from.
On the right side, pull the oil filler cap and the center plug out to tug from. The smaller cover has 2 dowel pins, the clutch cover has none. Tap with a plastic or rubber hammer if needed. Thanks for the info,very helpful.