10-27-2019, 02:17 PM
On a turn signal system based upon load, rather than time, a 6 ohm resistor (rated for 50 watts) is necessary to replace the load of two 27 watt (2.1 amp) incandescent elements on each side. If that is done, there is no battery load savings using LED.
I ran LED for brake/Tail (for longevity) but not for turns on the CB1100.
2 of the 4 can be replaced and still flash, but it will be a hyper flash.
I ran LED for brake/Tail (for longevity) but not for turns on the CB1100.
2 of the 4 can be replaced and still flash, but it will be a hyper flash.