+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Accessories/Modifications (https://cb1100forum.net/forum/forumdisplay.php?fid=8)
+--- Thread: Bar End Fitment (/showthread.php?tid=8793)
Bar End Fitment - jm00d_imp - 06-04-2018
N00b question - what is the bar end fitment for the 2014 standard cb1100? 7/8 hollow bar end?
Further context: I’m trying to install bar end mirrors. Also any recs for the bar end mirrors is appreciated!
RE: Bar End Fitment - SportsterDoc - 06-04-2018
Bars are 7/8 OD.
Never removed ends to measure ID.
RE: Bar End Fitment - peterbaron - 06-05-2018
(06-04-2018, 09:54 AM)jm00d_imp Wrote: N00b question - what is the bar end fitment for the 2014 standard cb1100? 7/8 hollow bar end?
Further context: I’m trying to install bar end mirrors. Also any recs for the bar end mirrors is appreciated!
OD = 7/8" = 0.875"
I believe that ID = 19 mm = 0.748031496 = 3/4" if conversion is correct
Also check this link
http://www.twistedthrottle.ca/kaoko-throttle-lock-cruise-control-honda-cbr600rr-08
Hope this helps.
pb
RE: Bar End Fitment - RoyP_imp - 06-06-2018
I bought bar end mirrors on Ebay but found a problem when I started to pull the old bar ends off the CB1100 DLX. The OEM bar ends fit inside the grips as well as the bar ends. The new bar end mirrors assume the grips end at the end of the handlebar. Any ideas?
RE: Bar End Fitment - Calcb_imp - 06-06-2018
If you’re replacing bar ends I would recommend the HVMP extra heavy ones. I like them a lot and they smooth out the handlebar even more than stock.