The CB1100 Community Forum
SW Motech engine guard saved the day - Printable Version

+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: SW Motech engine guard saved the day (/showthread.php?tid=845)

Pages: 1 2


SW Motech engine guard saved the day - 17-CB-002 - 06-30-2020

While riding alone in the countryside last Friday afternoon, I dropped the bike while entering into a side road. Did not even realised it until the bike was sliding on the loose gravel with me trapped from under.
Not too much damaged on the bike except for a bent front brake lever, broken right turn signal light and scratched exhaust and the tach chrome housing.
I must say that the SW Motech engine guard saved the bike from excessive damage.

I personally did not suffer any bruise or cuts, however, strained my muscles lifting the bike - trust me that 500 lbs chunk of metal is heavy to lift from the ground, only my pride was hurt.
Note: I tried to lift the bike using the back* technique, but, there were too much loose grave and my booths had no traction.

Today after receiving the brake lever, I installed it and took the opportunity to perform a full inspection on the bike.
Most important observation, the right side bent brake lever did not have the rubber thingie to protect it from damages - Since I lost it during the WV meet last year and I did not had the chance to replace it.(Karma?)
Damaged viewed from top.
Next task will be the engine guard paint job.


RE: SW Motech engine guard saved the day - Cormanus - 06-30-2020

That’s a bugger, Alain. I pleased to hear you’re okay and the bike is not badly hurt.


RE: SW Motech engine guard saved the day - michael1954 - 06-30-2020

(06-30-2020, 02:43 PM)Alain Lee_imp Wrote: While riding alone in the countryside last Friday afternoon, I dropped the bike while entering into a side road. Did not even realised it until the bike was sliding on the loose gravel with me trapped from under.
Not too much damaged on the bike except for a bent front brake lever, broken right turn signal light and scratched exhaust and the tach chrome housing.
I must say that the SW Motech engine guard saved the bike from excessive damage.

I personally did not suffer any bruise or cuts, however, strained my muscles lifting the bike - trust me that 500 lbs chunk of metal is heavy to lift from the ground, only my pride was hurt.
Note: I tried to lift the bike using the back* technique, but, there were too much loose grave and my booths had no traction.

Today after receiving the brake lever, I installed it and took the opportunity to perform a full inspection on the bike.
Most important observation, the right side bent brake lever did not have the rubber thingie to protect it from damages - Since I lost it during the WV meet last year and I did not had the chance to replace it.(Karma?)
Damaged viewed from top.
Next task will be the engine guard paint job.
Hope you are okay. I too have the crash bars on both CB's! I noticed those cool red reservoir covers!


RE: SW Motech engine guard saved the day - Houtman_imp - 06-30-2020

This is the reason that I tell new owners to put crash bars on ASAP !


RE: SW Motech engine guard saved the day - peterbaron - 06-30-2020

Alain, soon we ride again ...


RE: SW Motech engine guard saved the day - KiowaEagle_imp - 06-30-2020

Glad to hear that you are ok Alain. And yes, definitely karma, rlet up asap!


RE: SW Motech engine guard saved the day - PowerDubs_imp - 07-01-2020

Glad you are ok. There is a set of crash bars on Ebay used but like new for $120.

Would be better than paint on your right side, and a spare for your left.


RE: SW Motech engine guard saved the day - 17-CB-002 - 07-01-2020

(06-30-2020, 10:30 PM)KiowaEagle_imp Wrote: Glad to hear that you are ok Alain. And yes, definitely karma, rlet up asap!

I’ll try to install the RLET sometime this weekend to avoid karma again
(06-30-2020, 06:54 PM)michael1954_imp Wrote:
(06-30-2020, 02:43 PM)Alain Lee_imp Wrote: While riding alone in the countryside last Friday afternoon, I dropped the bike while entering into a side road. Did not even realised it until the bike was sliding on the loose gravel with me trapped from under.
Not too much damaged on the bike except for a bent front brake lever, broken right turn signal light and scratched exhaust and the tach chrome housing.
I must say that the SW Motech engine guard saved the bike from excessive damage.

I personally did not suffer any bruise or cuts, however, strained my muscles lifting the bike - trust me that 500 lbs chunk of metal is heavy to lift from the ground, only my pride was hurt.
Note: I tried to lift the bike using the back* technique, but, there were too much loose grave and my booths had no traction.

Today after receiving the brake lever, I installed it and took the opportunity to perform a full inspection on the bike.
Most important observation, the right side bent brake lever did not have the rubber thingie to protect it from damages - Since I lost it during the WV meet last year and I did not had the chance to replace it.(Karma?)
Damaged viewed from top.
Next task will be the engine guard paint job.
Hope you are okay. I too have the crash bars on both CB's! I noticed those cool red reservoir covers!
Hope you are okay. I too have the crash bars on both CB's! I noticed those cool red reservoir covers!
Mtneer has similar cover (blue) on his lovely bike and guided me on AliExpress


RE: SW Motech engine guard saved the day - E11even_Hunnit - 07-01-2020

That's a bummer. Glad to hear you were able to walk away with no major damage to your bike.

Just curious- How fast were you going?

Also, the guard looks scraped up but still in good shape, did it bend at all? Having those on did not only save your engine covers but also your tank it looks like Thumbs Up

I doubt the infamous RLET's would've done much for you in this situation..


RE: SW Motech engine guard saved the day - rboe - 07-01-2020

What is nice about those case savers - you can emery cloth and paint them, ready for a 2nd go around. If you buy new ones - keep them in the closet until you sell (if you ever do). It's a wear item and there is plenty of life left in them. Big Grin

Glad your gear was not tested. I have found that the case savers make it lot easier to lift up, prop the bike on the case savers, then back into the bike and pop her up.