+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: Is there a hugger available for cb1100? (/showthread.php?tid=612)
Is there a hugger available for cb1100? - Pauled_imp - 06-17-2021
Does anyone know if there is a hugger available for the cb ? The back of the engine was covered in crap, and It was a devil to clean between all fins there ,( is that the voltage regulator/rectifier there ?) If so another good reason for a hugger or alternative to keep it cleaner
RE: Is there a hugger available for cb1100? - Lord Popgun - 06-17-2021
Good question Paul. Haven’t seen that come up on the board herre, but I do have one on my ST1300. And yes, the voltage regulator/rect. is back there.
I’m going to search around for one, but—A quick look shows me that I could make one out of a piece of mud flap cut to fit. I just happen to have one. You can sometimes get them free from the side of the road. Tough stuff too!
RE: Is there a hugger available for cb1100? - GoldOxide_imp - 06-17-2021
Ensure there is still enough convection around the heat sink to help keep the rectifier cool.
RE: Is there a hugger available for cb1100? - Mixagon_imp - 06-18-2021
(06-17-2021, 10:01 PM)Lord Popgun_imp Wrote: Good question Paul. Haven’t seen that come up on the board herre, but I do have one on my ST1300. And yes, the voltage regulator/rect. is back there.
I’m going to search around for one, but—A quick look shows me that I could make one out of a piece of mud flap cut to fit. I just happen to have one. You can sometimes get them free from the side of the road. Tough stuff too!
Yes the cb1100 looks good for a homemade flap, its on my to do list.
I did this on my cb500 held on with velcro and it never came off.