+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: Can somebody get me some measurements? (/showthread.php?tid=591)
Can somebody get me some measurements? - FLYTYM_imp - 07-13-2021
On a stock 2014 Standard I need the distance from the bottom edge of the rear grab bar to the ground on the left side with the bike sitting on the side stand with the bars turned all the way to the left. Thank you.
RE: Can somebody get me some measurements? - Gone in 60 - 07-14-2021
If a '13 is the same, I just measured mine...
Low end (front of rail) 25.5"
High end (rear of rail) 27.5"
RE: Can somebody get me some measurements? - FLYTYM_imp - 07-14-2021
(07-14-2021, 09:13 AM)Gone in 60_imp Wrote: If a '13 is the same, I just measured mine...
Low end (front of rail) 25.5"
High end (rear of rail) 27.5"
Thank you,greatly appreciated.
RE: Can somebody get me some measurements? - Ben70_imp - 07-14-2021
I suspect the '13 is different. I think the '14 has a shorter side stand.
Ben
RE: Can somebody get me some measurements? - misterprofessionality - 07-14-2021
I have to know what this is for.
RE: Can somebody get me some measurements? - rboe - 07-15-2021
From the lowest point (the front of the grab bar), my '13 is 25-1/2", same as above.
However; on the '14. it's 25" measured at the same point.
RE: Can somebody get me some measurements? - Gone in 60 - 07-15-2021
I don't need to know.
My name is Paul, and this is between y'all.
RE: Can somebody get me some measurements? - FLYTYM_imp - 07-15-2021
(07-14-2021, 11:10 PM)misterprofessionality_imp Wrote: I have to know what this is for.
Shortening the center stand.