+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Mechanical & Technical (https://cb1100forum.net/forum/forumdisplay.php?fid=7)
+--- Thread: 2014 cb1100 Torque specs for two specific locations (/showthread.php?tid=4509)
2014 cb1100 Torque specs for two specific locations - Dd808_imp - 09-06-2021
Hello!
I am installing frame sliders and crank case covers to my 2014 CB1100. I am looking for the torque spec. Values for the following bolts:
The three bolts on the down tube and engine, indicated here with arrows.
The left and right crank case bolts, as indicated here with red circles.
The exhaust bolt, as indicated with a white circle.
RE: 2014 cb1100 Torque specs for two specific locations - Cormanus - 09-06-2021
Welcome Dd808.
RE: 2014 cb1100 Torque specs for two specific locations - GoldOxide_imp - 09-06-2021
Welcome to the Forum Dd808!
RE: 2014 cb1100 Torque specs for two specific locations - Lord Popgun - 09-06-2021
Welcome Dd!
All the muffler bolt is shown in the service manual as 15 ft lbs.
The engine mounting bolts on the downtube are 36 ft lbs. and the one on the engine is 44 ft lbs. The OEM bolts are pretty hefty.
The right cover does not have a torque spec. Manual says to apply sealant where shown and tighten securely.
The left cover also uses a sealant and has no torque spec. Says to tighten in a criss-cross pattern.
When no torque is spec’d, you can either wing it, or use the Standard Torque Values chart in the book. If you want it, PM me your email address and I’ll take a quick pic and send it to you.
RE: 2014 cb1100 Torque specs for two specific locations - Lord Popgun - 09-07-2021
Above should say The muffler bolt.
Not All the muffler bolt. Sorry.
RE: 2014 cb1100 Torque specs for two specific locations - Dd808_imp - 09-08-2021
Thank you all for the replies! Love this site… this was my first post and got my questions answered! Lord popgun, I found the standard torque specs from a previous thread! Thank you though
Any recommendations for the type of lock tite to use on the bolts?
RE: 2014 cb1100 Torque specs for two specific locations - Cormanus - 09-08-2021
So, Dd808, how about popping over to the New Members section and introducing yourself? Or just join in the fun.
RE: 2014 cb1100 Torque specs for two specific locations - Lord Popgun - 09-08-2021
Sorry I wasn’t clear Dd. No thread locker is called for on the covers bolts. The sealant I mentioned was for the cover mating surfaces as they have no gasket.
The engine mounting bolts also do not specify a locker.
RE: 2014 cb1100 Torque specs for two specific locations - Dd808_imp - 09-08-2021
(09-08-2021, 08:48 AM)Lord Popgun_imp Wrote: Sorry I wasn’t clear Dd. No thread locker is called for on the covers bolts. The sealant I mentioned was for the cover mating surfaces as they have no gasket.
The engine mounting bolts also do not specify a locker.
Copy that, thank you!!