+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: With a Center Stand do you even need a front stand? (/showthread.php?tid=3896)
Pages:
1
2
With a Center Stand do you even need a front stand? - PJV_imp - 10-19-2013
Just wondering of a front stand is needed to remove front wheel/forks?
RE: With a Center Stand do you even need a front stand? - the Ferret - 10-19-2013
I made a wooden block I prop under the headers on my FZ which holds the front end off the ground for front wheel removal, but I haven't tried it on the CB yet.
RE: With a Center Stand do you even need a front stand? - cbfan_imp - 10-19-2013
I bought a small jack from Harbor Freight and it fits under all my bikes............with bike on center stand place jack under front of engine and you can jack it onto the rear wheel which usually gives enough room to remove front wheel.
RE: With a Center Stand do you even need a front stand? - the Ferret - 10-19-2013
(10-19-2013, 10:54 PM)cbfan_imp Wrote: I bought a small jack from Harbor Freight and it fits under all my bikes............with bike on center stand place jack under front of engine and you can jack it onto the rear wheel which usually gives enough room to remove front wheel.
cbfan...have you tried it on the CB yet? I have one of those too I used to use on the Bonneville, and its been sitting under the workbench since I sold the Triumph. Didn't think about using that.
RE: With a Center Stand do you even need a front stand? - PJV_imp - 10-20-2013
if you were to place some weight or strap the rear wheel down, would there be enough room to lift front tire for removal forks? thanks
RE: With a Center Stand do you even need a front stand? - the Ferret - 10-20-2013
(10-20-2013, 12:05 AM)PJV_imp Wrote: if you were to place some weight or strap the rear wheel down, would there be enough room to lift front tire for removal forks? thanks
I would think so. You would need 10 1/2" of clearance between the ground and the bottom of your fork leg to remove it. Sitting on the tire I measure nearly 12".
RE: With a Center Stand do you even need a front stand? - cbfan_imp - 10-20-2013
Have not tried the jack thing on CB1100 yet...................but have used it on '70's CB550 and CB750.
RE: With a Center Stand do you even need a front stand? - Jim21680_imp - 10-20-2013
I just used a basic scissor jack under the bike about 10 minutes ago; worked very nicely. I placed a small block of wood under the two fins that come down in front of the oil drain bolt (they're plenty strong enough), and used that as the jack point. I'd probably make up something a bit more secure if I were to remove the front wheel, but for cleaning it, this makes it much, much easier.
RE: With a Center Stand do you even need a front stand? - AzBob_imp - 10-23-2013
Sure helps. You'd need the kind with the pin to take off the forks, there's another thread about all that somewhere. But there're workarounds, sling it from the rafters, use a jack, etc. None are as stable or efficient or safe as the right front stand but a good one will set you back a little.
A decent fork lift stand will run you about $75, head lift stand about $110 -- not really that much if you ask me, and worth it in terms of safety, IMO.
RE: With a Center Stand do you even need a front stand? - Deanohh_imp - 10-23-2013
Have used a head stand with several bikes. I like being able to have both wheels off at the same time.