The CB1100 Community Forum
Helmet lock unusable? - Printable Version

+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6)
+--- Thread: Helmet lock unusable? (/showthread.php?tid=3250)

Pages: 1 2 3 4


Helmet lock unusable? - pechorin75_imp - 03-16-2014

So am I missing something, or is it unusually difficult to use the helmet lock on this bike? I have a Bell RS-1 (which doesn't have an abnormally short chin strap, so far as I can tell), and I can't get the D-ring anywhere near the lock. The helmet shell hits the bike, and that's all the further she goes. Haven't tried another helmet yet, but I don't see any way the Bell is gonna hook up.

Anybody else have this experience? Is there some "secret" I'm missing?


RE: Helmet lock unusable? - lackskill_imp - 03-16-2014

It took me a couple minutes of fiddling to get my Shoei Neotec attached, but I eventually got it. FWIW, I haven't used it since. I just carry it with me.

Eventually I'm going to get a top box that I can stick my and my wife's helmets in.


RE: Helmet lock unusable? - kevbroce_imp - 03-16-2014

I use the helmet lock all the time with my Shoei RF-1100. It's a little tight, but not awful. There's basically 2 way you can go about it, you can have the left side of the helmet facing up, or the right side. On my Shoei, the D rings on the left side, I usually attach the helmet with the left side facing up towards the seat.


RE: Helmet lock unusable? - the Ferret - 03-16-2014

I bought a helmet guardian which goes across the back lic plate bracket

[url=http://smg.photobucket.com/user/theferret111/media/2013_04270022_zps5f8ebd25.jpg.html][Image: fd0b1519f8e7cb2204e10ba2b50f1581.jpg]


RE: Helmet lock unusable? - Gypped_imp - 03-16-2014

I can hook my Shoei Qwest and Multi-tec's with no problem, but I have noticed that it can be a little tight. I found that swapping the hand holding the d-rings helped a surprising amount.


RE: Helmet lock unusable? - dBuster_imp - 03-16-2014

I had the same hard time getting hooked on to the stock helmet lock.

Ferret, do you have a vendor or source for that helmet guardian? Is it the single or dual?

Sent from my XT1055 using Tapatalk


RE: Helmet lock unusable? - the Ferret - 03-16-2014

Mine is a dual, but my brother uses a single

http://www.helmetguardian.com

Looks like twisted throttle is carrying them

http://www.twistedthrottle.com/helmet-guardian-black


RE: Helmet lock unusable? - shdwghst457_imp - 03-16-2014

(03-16-2014, 01:09 PM)kevbroce_imp Wrote: I use the helmet lock all the time with my Shoei RF-1100. It's a little tight, but not awful. There's basically 2 way you can go about it, you can have the left side of the helmet facing up, or the right side. On my Shoei, the D rings on the left side, I usually attach the helmet with the left side facing up towards the seat.

I have the same experience with my RF-1100. It's a stretch to get it to connect, and then awkward to operate the key. Geometry on my old Shadow's helmet latch worked much better (and was spring-operated; didn't need the key to close).

Maybe running the strap as if I was wearing it at the time would be easier to get it on the hook. Wouldn't help prevent theft, but more secure than resting it on the mirror.


RE: Helmet lock unusable? - Pterodactyl_imp - 03-16-2014

No problem with Shark, AGV or Davida. Sometimes if doing by feel, instead of having a look, I get unlucky and try and put the D-ring over the lock mechanism instead of the hook. After fumbling, and muttering various incantations for a short while I have look and get it right. Sometimes I also fit a helmet bag cord as well as the D-ring over the hook. No great problem, but you are right, Pechorin75, in that I have had other bikes that have easier access.

Cheers.


RE: Helmet lock unusable? - Rolls_imp - 03-16-2014

You are right, Pechorin75, I have had other bikes that have easier access, but I use the CB1100 helmet lock regularly with my Bell RS-1. Great helmet, btw.