+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Mechanical & Technical (https://cb1100forum.net/forum/forumdisplay.php?fid=7)
+--- Thread: Break in oil? (/showthread.php?tid=6146)
RE: Break in oil? - Dakota_imp - 01-26-2014
The owner's manual for my wife's 1947 Chevy states "The crankcase of the engine in this vehicle as received by you is filled with a light body 'breaking-in" oil. Use this oil only during the breaking-in schedule shown below. It should not be used after the breaking-in schedule"
Clearly, break in oil has been around for quite awhile and continues to find applications.
RE: Break in oil? - mininsx_imp - 01-27-2014
(01-25-2014, 02:22 AM)Randy B_imp Wrote: I could go on, but suffice to say it's no myth.
"Years ago" oil had MUCH higher levels of [url=http://en.wikipedia.org/wiki/Zinc_dithiophosphate]ZDDP than it does now due to tighter emissions regulations. With the proliferation of roller valve trains the need for it has been reduced and this had allowed the government to pass more stringent regulations in regards to ZDDP and thus "break in oil" was born. It is ONLY to be used for short periods to break in an engine, not full oil change intervals UNLESS the engine is of a flat tappet design with no catalyst. ZDDP destroys the catalyst in a much shorter time frame than it would normally wear out.
Hahaha OK, I give!
I'd never seen it before anywhere.
RE: Break in oil? - the Ferret - 01-27-2014
(01-27-2014, 02:10 AM)mininsx_imp Wrote:(01-25-2014, 02:22 AM)Randy B_imp Wrote: I could go on, but suffice to say it's no myth.
"Years ago" oil had MUCH higher levels of [url=http://en.wikipedia.org/wiki/Zinc_dithiophosphate]ZDDP than it does now due to tighter emissions regulations. With the proliferation of roller valve trains the need for it has been reduced and this had allowed the government to pass more stringent regulations in regards to ZDDP and thus "break in oil" was born. It is ONLY to be used for short periods to break in an engine, not full oil change intervals UNLESS the engine is of a flat tappet design with no catalyst. ZDDP destroys the catalyst in a much shorter time frame than it would normally wear out.
Hahaha OK, I give!
Don't feel bad, I've never seen that either.