![]() |
|
Speedo/Tacho Gauge alignment? - Printable Version +- The CB1100 Community Forum (https://cb1100forum.net/forum) +-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5) +--- Forum: Mechanical & Technical (https://cb1100forum.net/forum/forumdisplay.php?fid=7) +--- Thread: Speedo/Tacho Gauge alignment? (/showthread.php?tid=4858) |
RE: Speedo/Tacho Gauge alignment? - Ack-CB11_imp - 02-19-2020 (02-19-2020, 01:49 AM)Bazbro_imp Wrote: Well, that's THREE nutcases on here, and we're all from England.... (02-19-2020, 06:54 AM)The ferret_imp Wrote: Luv it, too funny. ACK RE: Speedo/Tacho Gauge alignment? - pdedse - 02-19-2020 (02-19-2020, 06:54 AM)The ferret_imp Wrote: Yeah, but I'm betting your RLETs are lined up just right. (I know mine are!)
RE: Speedo/Tacho Gauge alignment? - GoldOxide_imp - 02-19-2020 (02-19-2020, 01:44 PM)pdedse_imp Wrote:(02-19-2020, 06:54 AM)The ferret_imp Wrote: RE: Speedo/Tacho Gauge alignment? - 17-CB-002 - 02-19-2020 My 17' EX also has that same issue, it gave the impression that the handle bar is not properly aligned, i.e. one of the grip seemed closer to the rider than the other side. So I loosened the 2 handle bar stem nuts under the top bridge (triple clamp), twisted the handle bar left/right to each stop a few times to reseat the clamps and re-torqued without any improvement. At the time I noticed that the 2 clamps were mounted on rubber washer, so I figured that may be the rubber washers were the issue because the handle bar straight section when eyeballed against the 2 forks at the top bridge is not aligned. Note: The bike was never dropped or strapped on a trailer. The bike when new is held via the 2 handlebar clamps to the shipping crate via an extension bracket. (will provide the picture once I figured out how to reduce the picture file size). Will investigate further when the weather gets warmer. Regards Alain RE: Speedo/Tacho Gauge alignment? - GoldOxide_imp - 02-19-2020 Uh, oh. The illusion is becoming real?
RE: Speedo/Tacho Gauge alignment? - Charlie Bravo_imp - 02-20-2020 You're not seeing things. The gauges on my '13 are a tiny bit out of whack, and I've posted on this forum before about it. Not much, just a bit, but it's there. RE: Speedo/Tacho Gauge alignment? - peterbaron - 02-20-2020 (02-19-2020, 01:51 PM)GoldOxide_imp Wrote:(02-19-2020, 01:44 PM)pdedse_imp Wrote:(02-19-2020, 06:54 AM)The ferret_imp Wrote: ^ ....glad, I don't have THIS problem...
RE: Speedo/Tacho Gauge alignment? - GoldOxide_imp - 02-20-2020 (02-20-2020, 02:51 AM)peterbaron_imp Wrote:(02-19-2020, 01:51 PM)GoldOxide_imp Wrote:(02-19-2020, 01:44 PM)pdedse_imp Wrote:(02-19-2020, 06:54 AM)The ferret_imp Wrote: ^ ....glad, I don't have THIS problem... ^^^ Never say never. ^^^
RE: Speedo/Tacho Gauge alignment? - the Ferret - 02-20-2020 I dont think my turn signals are all aligned the same, but after 48,000 miles the rest of the bike is so good, I'm willing to ignore it. RE: Speedo/Tacho Gauge alignment? - Ben70_imp - 02-20-2020 That is just fine for you, Mr. Ferret, Defender of the Realm! You ride on by with your turn signals out of alignment, and YOU can't see them. The rabble are left in an emperors new clothes type situation, you know? Shall we tell him? Wink wink, nudge nudge. It would seem that a Ferret of your standing would be a bit more concerned with keeping up appearances, eh? Guess I'd better tone it down. Don't want my rlets disappearing in the middle of the night, perhaps accompanied by a ransom note or some such. Ben |