+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Mechanical & Technical (https://cb1100forum.net/forum/forumdisplay.php?fid=7)
+--- Thread: stupid question perhaps - oil change before/after valve check? (/showthread.php?tid=5538)
Pages:
1
2
RE: stupid question perhaps - oil change before/after valve check? - postoak_imp - 08-02-2016
Is checking the valve clearance yourself all that hard really?
RE: stupid question perhaps - oil change before/after valve check? - the Ferret - 08-02-2016
It depends on your mechanical aptitude. You have to remove so e parts, including the valve cover which covers the top of the motor, and a side cover, turn the crank until one set of valves are open, be able to feel the amount of drag on a feeler gauge rotate the motor until the other set of valves are open and again feel the drag on a different feeler gauge, and determine by those measurement if the valve clearance is withn tolerance or not.
If they are its pretty easy and you button everything up. IF not THEN it gets complicated.
RE: stupid question perhaps - oil change before/after valve check? - postoak_imp - 08-02-2016
I've had the cam cover off on my Nighthawk. Especially with a Haynes or Clymers I think most could do this and if everything is okay zip things back up. If not okay, I suppose you have to take the cam shaft off and replace shims or you could take it to the dealer then.