![]() |
|
Frequent/occasional difficulty inserting key in ignition? - Printable Version +- The CB1100 Community Forum (https://cb1100forum.net/forum) +-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5) +--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6) +--- Thread: Frequent/occasional difficulty inserting key in ignition? (/showthread.php?tid=1715) |
RE: Frequent/occasional difficulty inserting key in ignition? - Bheezy27403_imp - 10-13-2017 Smooth as silk. RE: Frequent/occasional difficulty inserting key in ignition? - Ben70_imp - 10-14-2017 Try squirting the key with WD40 and then insert it and run it in and out a few times while wet. I don't like putting much of anything in there to attract dust. Yes, I have experienced that "problem" as well. Ben RE: Frequent/occasional difficulty inserting key in ignition? - Nortoon_imp - 10-14-2017 When washing the bike I put a strip of hockey shin pad tape over the ignition lock to keep any water or soap out. I have not had any problem with the EX. My CB500XA did not like the key inserted from the left of the bike. I had to be on the mounting (right) side.
RE: Frequent/occasional difficulty inserting key in ignition? - Rocky_imp - 10-14-2017 (10-13-2017, 10:45 PM)COCB1100_imp Wrote: I was super frustrated the other week while in a rush and needing to go somewhere when my key wouldn't go in. Was trying my best and losing my patience when I realized it would help tremendously if I was trying to insert the right key. Hahaha. Good thing I didn't cause any damage with my futile attempts. That reminds me of a couple of weeks ago when I was trying to kick-start my old BSA and it wouldn't fire - until I turned the ignition key on
RE: Frequent/occasional difficulty inserting key in ignition? - Nortoon_imp - 10-14-2017 (10-14-2017, 05:24 AM)Rocky_imp Wrote:(10-13-2017, 10:45 PM)COCB1100_imp Wrote: I was super frustrated the other week while in a rush and needing to go somewhere when my key wouldn't go in. Was trying my best and losing my patience when I realized it would help tremendously if I was trying to insert the right key. Hahaha. Good thing I didn't cause any damage with my futile attempts. Now you have my interest! What kind of Beezer do you have? RE: Frequent/occasional difficulty inserting key in ignition? - Cormanus - 10-14-2017 Rocky's signature says it's a '67 BSA 441 VR'.
RE: Frequent/occasional difficulty inserting key in ignition? - Rocky_imp - 10-14-2017 (10-14-2017, 06:22 AM)Cormanus_imp Wrote: Rocky's signature says it's a '67 BSA 441 VR'. Yup, it's a fully restored 1967 BSA 441cc single cylinder Victor Roadster. Had it since 2000 and put a lot of work into it. Frequent/occasional difficulty inserting key in ignition? - COCB1100_imp - 10-14-2017 (10-14-2017, 07:34 AM)Rocky_imp Wrote:(10-14-2017, 06:22 AM)Cormanus_imp Wrote: Rocky's signature says it's a '67 BSA 441 VR'. Yup, it's a fully restored 1967 BSA 441cc single cylinder Victor Roadster. Had it since 2000 and put a lot of work into it. More work than trying to kick start it with the key out of the ignition? at least that's a good workout. Maybe you're onto something instead of spin classes with classrooms full of stationary bicycles...Sent from my iPhone using Tapatalk RE: Frequent/occasional difficulty inserting key in ignition? - Nortoon_imp - 10-14-2017 (10-14-2017, 07:34 AM)Rocky_imp Wrote:(10-14-2017, 06:22 AM)Cormanus_imp Wrote: Rocky's signature says it's a '67 BSA 441 VR'. Nice! Apparently the BSA name is going to be revived in India. Different engine in this new release though.
RE: Frequent/occasional difficulty inserting key in ignition? - jimgl3_imp - 10-14-2017 with every bike I have ever owned. yes |