![]() |
|
You know it’s not a good day when... - Printable Version +- The CB1100 Community Forum (https://cb1100forum.net/forum) +-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5) +--- Forum: General Discussion (https://cb1100forum.net/forum/forumdisplay.php?fid=6) +--- Thread: You know it’s not a good day when... (/showthread.php?tid=1510) Pages:
1
2
|
RE: You know it’s not a good day when... - Cormanus - 04-15-2018 This is how you change oil, http://cb1100forum.com/forum/showthread.php?tid=10993 RE: You know it’s not a good day when... - flynrider - 04-16-2018 (04-14-2018, 11:48 PM)PowerDubs_imp Wrote: When I was just a few years into driving, I changed the oil on a car but did not notice the old rubber seal from the filter stayed stuck to the block. Needless to say 2 rubber seals do NOT work better than one. Even worse on a CB, as the filter will dump the oil right in front of the rear tire. I think I've seen a few posts over the years where someone on the forum made this mistake. One of the things I always do after removing the old filter is to run my finger around the seating surface to make sure it's smooth and free of debris. RE: You know it’s not a good day when... - TCinNC_imp - 04-16-2018 (04-15-2018, 06:50 AM)Cormanus_imp Wrote: This is how you change oil, http://cb1100forum.com/forum/showthread.php?tid=10993 ![]() It ended up being not so bad. Cleaned up the drain pan and only lost half a quart when I pulled the drain plug and put the washer back on. All is good! |