The CB1100 Community Forum

(09-04-2015, 05:52 AM)Inhouse Bob_imp Wrote: [ -> ]

(09-04-2015, 05:14 AM)veech_imp Wrote: [ -> ]Ah, thank you popgun. I should have gone back and reread the thread before posting the question.

Thanks Popgun. I woulda just rewritten it all as I forgot I said it before
The biggest challenge in the install was getting an allen wrench under the handle bars to adjust the risers. Others have mentioned this as well. It's a very tight space, especially if you are going for a lot of pull back. Not a good design. We ground down a wrench until it fit, but it was so short that it was hard to get a solid bite on the head.

Glad I could help!

Took a medium to long ride today and found the new bar position to be much better for me. I'm sitting more erect and can slide around on the seat more to maintain circulation in my butt. I can now sit in the "bucket" of the Corbin seat without having to over reach. All is right with the world.

(09-05-2015, 07:01 AM)Inhouse Bob_imp Wrote: [ -> ]Took a medium to long ride today and found the new bar position to be much better for me. I'm sitting more erect and can slide around on the seat more to maintain circulation in my butt. I can now sit in the "bucket" of the Corbin seat without having to over reach. All is right with the world.

Indeed!