(12-08-2016, 02:56 AM)The ferret_imp Wrote: [ -> ]Or just not worry about it. It's not going to fall off. Does it leak at the joint?
Not sure if it's leaking how would I test that?
Listen for a leak, or put some soapy water around joint and see if it blows bubbles
Holy,
I have an Arrow and it doesn't move that much. It seems like you may be missing the collar (No. 11 in the pic) that prevents that movement.
(12-08-2016, 04:46 AM)Nemo_imp Wrote: [ -> ]Holy,
I have an Arrow and it doesn't move that much. It seems like you may be missing the collar (No. 11 in the pic) that prevents that movement.
Yes! I am missing that piece! Snap what site is that on?
(12-08-2016, 04:46 AM)Nemo_imp Wrote: [ -> ]Holy,
I have an Arrow and it doesn't move that much. It seems like you may be missing the collar (No. 11 in the pic) that prevents that movement.
Am I supposed to use the gasket? I could get that to fit.
Click [url=http://www.partsfish.com/oemparts/a/hon/52f28c02f870021404ec5a46/exhaust-muffler-1]HERE
I don't remember a gasket... If it's there, it never came out when I took off the factory muffler or when I had the headers finished.
I fixed it! Thanks everyone for the help.
I has the insert I had everything I needed just used the wrong exhaust clamp... I had to torque the new down a bit and now it's solid as a rock. I used my yoshimura clamp which maxed out before it was tight enough. Should be good now!
