The CB1100 Community Forum

These helped move bars up an inch and back about 1 3/8 inch.
Seating position is more upright and neutral now

(10-30-2017, 12:14 PM)Mscb1100_imp Wrote: [ -> ]These helped move bars up an inch and back about 1 3/8 inch.
Seating position is more upright and neutral now

If you would please tell me what exact model# you ordered. I had looked awhile back and could not find them. Were you able to use all stock cables and lines after install? Thank you in advance for your assistance.

(12-04-2017, 09:18 PM)Spiderwatts_imp Wrote: [ -> ]

(10-30-2017, 12:14 PM)Mscb1100_imp Wrote: [ -> ]These helped move bars up an inch and back about 1 3/8 inch.
Seating position is more upright and neutral now

If you would please tell me what exact model# you ordered. I had looked awhile back and could not find them. Were you able to use all stock cables and lines after install? Thank you in advance for your assistance.

If you would please tell me what exact model# you ordered. I had looked awhile back and could not find them. Were you able to use all stock cables and lines after install? Thank you in advance for your assistance.
go to genmar webpage
It is part # x102 for aluminum

part # 102b for black

they are 1 inch up and 1 3/8 inch back

I used stock cables and wiring, did not have to make any modifications.

PS, you will need to go by Honda to get two more caps, they are about 1.19 a piece

I put the same ones on my 2014 Standard this summer. Instant improvement, took the pressure off of my hands and I sit more upright. The only down side is that now when I turn hard left my tank bag hits the horn button. Startles me every time.

I used the same model riser on 2013 and did have to replace the brake line with a longer one.

(12-05-2017, 03:51 AM)Mscb1100_imp Wrote: [ -> ]

(12-04-2017, 09:18 PM)Spiderwatts_imp Wrote: [ -> ]

(10-30-2017, 12:14 PM)Mscb1100_imp Wrote: [ -> ]These helped move bars up an inch and back about 1 3/8 inch.
Seating position is more upright and neutral now

If you would please tell me what exact model# you ordered. I had looked awhile back and could not find them. Were you able to use all stock cables and lines after install? Thank you in advance for your assistance.

If you would please tell me what exact model# you ordered. I had looked awhile back and could not find them. Were you able to use all stock cables and lines after install? Thank you in advance for your assistance.
go to genmar webpage
It is part # x102 for aluminum

part # 102b for black

they are 1 inch up and 1 3/8 inch back

I used stock cables and wiring, did not have to make any modifications.

PS, you will need to go by Honda to get two more caps, they are about 1.19 a piece

If you would please tell me what exact model# you ordered. I had looked awhile back and could not find them. Were you able to use all stock cables and lines after install? Thank you in advance for your assistance.
go to genmar webpage
It is part # x102 for aluminum

part # 102b for black

they are 1 inch up and 1 3/8 inch back

I used stock cables and wiring, did not have to make any modifications.

PS, you will need to go by Honda to get two more caps, they are about 1.19 a piece
Thank you!!