I'm searching for a bar that looks just like stock with 1-2 inches taller grip location. Prefer not to add riser hardware to the clamps. Not had much luck so far.
Question - Does the 2014 STD have lugs in the handlebar switches that fit into holes in the stock bars?
Check the Flanders website for a great selection of handlebars.
yes the 14 has holes for the controls
(03-13-2021, 10:23 AM)cj599_imp Wrote: [ -> ]yes the 14 has holes for the controls
Cut off the tabs, or drill the bars?
Id drill the controls really dont clamp very tight so the holes keep them from twisting
(03-14-2021, 10:15 PM)cj599_imp Wrote: [ -> ]Id drill the controls really dont clamp very tight so the holes keep them from twisting
Thank you everyone for the help and suggestions. I will drill the new bars in the same spot as stock. Just need to find the right bars. Has anyone else out there done the same thing?
(03-13-2021, 08:48 AM)DBM_imp Wrote: [ -> ]I'm searching for a bar that looks just like stock with 1-2 inches taller grip location. Prefer not to add riser hardware to the clamps. Not had much luck so far.
Question - Does the 2014 STD have lugs in the handlebar switches that fit into holes in the stock bars?
Hi, I do not know if anyone else here read this, but I was reading an old magazine review for the 2013 CB1100, I think from Cycle or Cycle World, not sure. But they said you can turn the handlebar risers around and elevate the handlebars to give the bike and easier reach. Did anyone out there remember reading that review? I have been tempted to try it, but the bars on all 3 of my CB's suit me just fine.
(03-28-2021, 04:26 PM)michael1954_imp Wrote: [ -> ] (03-13-2021, 08:48 AM)DBM_imp Wrote: [ -> ]I'm searching for a bar that looks just like stock with 1-2 inches taller grip location. Prefer not to add riser hardware to the clamps. Not had much luck so far.
Question - Does the 2014 STD have lugs in the handlebar switches that fit into holes in the stock bars?
Hi, I do not know if anyone else here read this, but I was reading an old magazine review for the 2013 CB1100, I think from Cycle or Cycle World, not sure. But they said you can turn the handlebar risers around and elevate the handlebars to give the bike and easier reach. Did anyone out there remember reading that review? I have been tempted to try it, but the bars on all 3 of my CB's suit me just fine.
Hi, I do not know if anyone else here read this, but I was reading an old magazine review for the 2013 CB1100, I think from Cycle or Cycle World, not sure. But they said you can turn the handlebar risers around and elevate the handlebars to give the bike and easier reach. Did anyone out there remember reading that review? I have been tempted to try it, but the bars on all 3 of my CB's suit me just fine. I am curious if anyone has tried this and how it worked out.
Anyone?
Beuller? Beuller?